Brown One Part Epoxy Ink, Quart
Properties: Superior adhesion to epoxy, glass, metal or other nonporous surfaces. Excellent resistance to abrasion and flux removing solvents. This ink is cured by baking. The cured ink meets: CID A-A-56032D Types I, II & III, Formerly: MIL-I-43553b.
CURE CYCLES: This ink is cured by baking at one of the following time/temperature cycles, allowing time for the printed surface to reach the selected temperature:
Minimum Temperature:
300° F. (149° C.) - 30 minutes
350° F. (177° C.) - 6 minutes
POT LIFE: Essentially unlimited pot life. Can be used over extended periods of time.
SHELF LIFE: 6 Months, stored in a refrigerator. Ink must be stirred prior to each use.
Do not subject to above normal room temperature.
DIRECTIONS FOR USE: This ink is suitable for rubber stamp or offset printing. When used with a rubber stamp, roll the ink into a thin draw down on a glass, metal or plastic plate with a brayer roller or similar device, before transferring to the stamp. When used with a rubber stamp, use a brayer roller or similar device to roll the ink into a thin draw down before transferring to the stamp.
Please let us know if you need the Glass Plate, and Roller, and the type of marking device needed to complete your order.
Questions or comments call us at 323-582-6461 or email us at info@HPRubberStamp.com