RIBtype Marking Devices
RIBtype® Stamp Mounts can create a perfect solution for any and all part marking. These
wood handle hand stamps, or self-inking metal frames stamps are equipped
with the rib backing to be used with RIBtype® rubber type/numbering
kits.
Rib Direction:
We recommend and, unless directed otherwise, make all rocker stamps
with the ribs running the same direction as the rocking motion. Running
the ribs at a right angle to the rocking direction can result in ribs
being spread apart and can cause 2-rib RIBtype® to fall out and make
type, logos, or mats with several ribs difficult or impossible to
insert.
Handles: For larger rocker mounts, an aluminum
"G" handle (shown in picture to the right) provides a better imprint
and reduces fatigue. It is available on wooden rockers at least 2" x 5"
and is attached to the wood block by 4 screws. All aluminum rockers come
with a "G" handle.
Wood Rocker Lengths:
Standard wood rocker lengths (length of ribs in the curved direction)
are 3", 4", 5", 6", and 8". 8" is the maximum length in the rocking
direction. If greater lengths are required, we can make curved aluminum
bases by quote.
Questions or comments call us at 323-582-6461 or email us at info@HPRubberStamp.com